We can support you from the feasibility phase until production throughout different steps
We design and customize RF antennas to your challenging environments, including packaging and potting. As each project is unique, we guide you through the most cost and scope efficient solutions.
In some cases, typically multiband antennas, the implementation process includes the fine tuning of the antenna before the determination of the matching circuitry.
Depending on your requirements (cost, space, operating environment), we can propose the best design for your product, typically
The deliverable is a set of prototype antennas with a characterization report. If the product casing is filled with potting resin - for example in ATEX environments - its permittivity is determined at the operating frequency. Upon request, a temperature characterization may be performed.
2014
parking meter
Multiband matching of a 3G ceramic antenna in harsh environment
2015
datalogger
Design and characterization of a 869 MHz PIFA (50 ohms impedance without specific matching circuit)
2015
datalogger
Matching of an embedded GPS ceramic antenna
2017
datalogger
Design and characterization of a 915 MHz PIFA (50 ohms impedance without specific matching circuit)
2017
parking sensor
Design and characterization (including temperature) of a 863-870 MHz potted PIFA
2018
LoRa gateway
Fine tuning of a 869MHz whip antenna
2018
Sensor
Design and characterization of a 869 MHz potted IFA (50 ohms impedance without specific matching circuit)
2019
datalogger
Design and characterization of a 2.45 GHz (Bluetooth) potted IFA (50 ohms impedance without specific matching circuit)
2019
datalogger
Design and characterization of a 1.575 GHz (GPS) potted IFA (50 ohms impedance without specific matching circuit)
2019
interface
Design and characterization (including temperature) of a 869 MHz potted IFA (50 ohms impedance without specific matching circuit)
2019
audio device
Selection and implementation of WiFi and BLE antennas, as a replacement for a defective design
2020
audio device
Design and characteriatîzation of a 5.8GHz IFA (50 ohms impedance without specific matching circuit)
2020
parking meter
Tuning and multiband matching of an LTE ceramic antenna in harsh environment
2020
GPS
Matching of an embedded GPS ceramic antenna
2020
Bluetooth
Selection and implementation of a BLE antenna